Headphone EQ

Beats Fit Pro EQ settings for Mac

Last updated: September 15, 2026

Beats Fit Pro has one published AutoEQ correction, measured by Rtings, and it is on this page in full. Below is the curve, the exact parametric filters behind it, and a one-click preset for EQBase. macOS has no system-wide equalizer of its own, so applying a correction to everything your Mac plays, rather than inside a single player, needs an app that sits on the system audio path.

Worth knowing: One rig, Rtings, but what it found is the flattest headphone on this site bar one: no band moves by more than 2 dB and the preamp asks for only 2.3 dB of headroom. Applying this is a subtle change by design rather than a broken download. If you want to hear whether it is doing anything at all, compare it on material with a lot of upper midrange in it.

Each measurement below carries four things: the correction curve, its parametric filters, the same filters as copy-paste text in AutoEQ's format (which Equalizer APO and Peace, REW and most desktop parametric equalizers import, and which EQBase's own Expert EQ reads and writes), and EQBase's ten-band fit of that correction. The ten-band figures are what the downloadable preset applies, so what you hear matches what is written here. AutoEQ publishes its own ten-band file on the same grid, fitted to the raw measurement rather than to these filters, so the two agree closely through the midrange and can differ at the extremes.

The correction, measurement by measurement

Preamp: -2.3 dB
Filter 1: ON LSC Fc 105 Hz Gain 1.8 dB Q 0.70
Filter 2: ON PK Fc 313 Hz Gain 2.3 dB Q 0.84
Filter 3: ON PK Fc 5866 Hz Gain -4.4 dB Q 4.07
Filter 4: ON PK Fc 2445 Hz Gain -2.7 dB Q 2.06
Filter 5: ON PK Fc 40 Hz Gain -3.7 dB Q 0.92
Filter 6: ON HSC Fc 10000 Hz Gain 1.0 dB Q 0.70
Filter 7: ON PK Fc 1263 Hz Gain -1.4 dB Q 2.35
Filter 8: ON PK Fc 4035 Hz Gain 1.8 dB Q 4.11
Filter 9: ON PK Fc 5017 Hz Gain -1.4 dB Q 6.00
Filter 10: ON PK Fc 942 Hz Gain 0.7 dB Q 4.33

What this correction changes

The largest boost is +1.7 dB at lower midrange (250 Hz), and the largest cut is −2.0 dB at upper midrange (2 kHz). Total swing across the ten bands is 3.7 dB. Across the three thirds of the band the average movement stays under a decibel, so this is a fine-detail correction rather than a tonal rebalance.

With a single published measurement there is nothing to cross-check the figures against, so treat them as a good starting point rather than a settled answer, and trust your own ears over the last decibel.

Applying this on a Mac

The Beats Fit Pro is an in-ear monitor, and its bass depends far more on the seal than on anything in this correction. A tip that does not seal loses the low bass outright, and no amount of boost puts it back. If the bottom end still sounds missing after applying this, change tips and re-seat them before deciding the curve is wrong.

Most of the measurements behind this page were made with the headphone in its normal listening mode, and active noise cancelling changes the response it is correcting. Switching ANC or transparency on and off is not a small tone change, so a correction that sounds right in one mode may not in another.

In EQBase the fastest route skips this page entirely: open the Headphones pane, search for your model, and apply the correction. The Beats Fit Pro is in the built-in catalog along with 8,665 other models. The preset above exists for people who want to see the numbers first, or who want a specific measurement rather than the default one.

Either way the correction applies to every app at once, and the free tier carries it with no time limit. The Beats Fit Pro preset above sets the ten-band curve, which is what the free tier applies, so nothing on this page is behind a purchase.

Common questions

Do these EQ settings work on any Mac app?

Yes, if the equalizer runs on system audio rather than inside one player. EQBase processes everything the Mac plays, so the same correction applies to Spotify, Safari, YouTube, games and calls. The Music app's own equalizer only affects Music.

Where do the Beats Fit Pro numbers come from?

From one published AutoEQ measurement of the Beats Fit Pro, made by Rtings. AutoEQ computes the correction by comparing that measured frequency response against a target curve, so the filters below are only as good as that single measurement: with nothing to cross-check it against, treat it as one informed opinion rather than a consensus.

Why is the Beats Fit Pro preamp negative?

The Beats Fit Pro correction needs −2.3 dB of headroom on its default measurement, so the preset pulls the signal down by that much before the boosts are applied. Boosting a signal that is already near full scale would clip it, and the negative preamp is what buys the room. Skip it and loud passages distort. That is a small figure, meaning this correction is mostly cuts rather than boosts, so it costs very little loudness.

Can I use these filters in a different equalizer?

Yes. The filter table is a standard parametric list: type, frequency, gain and Q. Any parametric equalizer that accepts those four values per band will take them, on any platform. The one-click preset is only a shortcut for EQBase users.

Other headphones with published corrections

• Apple AirPods 3 EQ settings for Mac, 2 published measurements
• Audio-Technica ATH-M50x EQ settings for Mac, 9 published measurements
• Beats Powerbeats Pro 2 EQ settings for Mac, 1 published measurement
• Beats Solo 4 EQ settings for Mac, 1 published measurement
• Beats Studio Pro EQ settings for Mac, 1 published measurement

Credits

Correction data from the AutoEQ project by Jaakko Pasanen, used under the MIT licence. The measurements themselves are the work of the people credited on each curve above. EQBase ships the same catalog in the app, with the same attribution.

All headphone EQ pages · Does macOS have a built-in equalizer? · Room correction on a Mac